Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

What would you do?

I have connected a Cisco VPN 3030 to our network. I assigned the IP Address to each interface and set a static route which is showing as the public interface. I am not able to ping any interface and I can't run a ping from the concentrator to anything. I see my default gateway is set to the same subnet as my public interface is set to. Shouldn't that be the private? (See edited example attached). Thanks for your help.

5 REPLIES
Cisco Employee

Re: What would you do?

Hi,

The IP addresses and the default gateway look fine. It could be related to the filters on the interfaces. Please check if the filters permit ICMP. Where are you pinging from? Private network or Internet?

Regards,

Kamal

New Member

Re: What would you do?

Hi Kamal,

I am pinging from the network (inside) which this concentrator is connected too. Although the interfaces show UP as I said I can not ping out or ping to the concentrator.

Thanks for your reply -

Dan

New Member

Re: What would you do?

Kamal,

I did not change any of the default filters for any of the interface except the External interface. I applied "none" as we would use it for internal management control.

Thought you should know -

Dan

Cisco Employee

Re: What would you do?

Hi Dan,

Please configure the 'Private' filter on the private interface. See if that makes a difference.

HTH,

Kamal

New Member

Re: What would you do?

Kamal,

I can not see any ARP from the devise, so I am wondering is there something that I need to enable on the interfaces themselves? I changed all the vlans to the same just to see if I can detect any ARP message, but no luck.

Thanks for the replies - Dan

88
Views
0
Helpful
5
Replies
CreatePlease login to create content