It depends. The best way to use SSH command is to use the PAT IP if you are using PAT. If not, you could use PIX2's outside interface. If you are using NAT (in global), you could assign a static mapping to the PC that will manage PIX. does this help?
Do the following, in the case of Site-to-Site VPN. Add access-list statement between the workstation that needs to manage the remote PIX and the outside interface address of remote PIX. This access-list ID shall be listed in nat(inside) 0 statement. Similar access-list statement shall be added in the remote PIX too.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...