i have a question and it will be highly appreciated if any1 gives me the right answer with the reason...thnx
Q. i have three T1 lines which are serially connected to the router and these T1 line are dedicated to each Gateways which are placed beside the router....these gateways provides services such as HTTP and VPN connectivity. Now, i have a scenario in which if single T1 line fails then router must load balance the data i,e; route the packets of failed T1 from other 2 T1 lines while these 2 T1 lines are already servicing to their respected gateways...is that possible...and which router i required to place in network..
if u want to see the diagram then please follow the attachements..thnx
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...