Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

why pix525 auto-reload?

hi,i have a pix525 as nat device for local network to internet. Recently it would

auto reload without any information. sometimes it did once a day,sometimes it would did once after more than 5 days.i set a syslog server,level is 5,because information was too big to open it. i only set lelvel as 3, i can't find any information about reload, only a lot of message %pix-3-106011.

The pix' version is 6.0(1).i guss that bug cause it or someone attack it.

do you know what cause reload?can you help me?

thanks!

2 REPLIES
Cisco Employee

Re: why pix525 auto-reload?

It's impossible to say without any sort of traceback output. Next time you could plug a console into the console port and then when it reloads you should get a traceback message, we cna then use this to see what was going on.

In the interim, you might want to upgrade to 6.2(2) which is probably more stable than 6.0(1).

New Member

Re: why pix525 auto-reload?

this may be because of the license. a pix with a failover-only license will reload every 24 hours if a fully licensed partner can not be found. it could also indicate buffer exhaustion (look at "show block") or a bug.

116
Views
0
Helpful
2
Replies
CreatePlease login to create content