Win9X clients logging in and browsing via VPN 3000
When a remote Win9X client tries to log into a domain without a tunnel, it times out (of course). Then, if you establish a client VPN connection, you get layer 3 connectivity and can browse by IP address or use LMhosts file entries. If you try to log off and log into the domain, you lose your tunnel. So can someone please point me to the document that explains how you establish a tunnel and then Log into the domain? With Win2K the Tunnel comes up before the actual client-->Domain authentication happens. How do you do it in Win9X? Also, I tried configuring WINS and DNS servers for my groups, but but they only recieve the address of the DNS server, not the WINS server. Worthy of note: I am using a Win2K server, not NT. I am running WINS and DNS on it. I am only able to browse by IP address at this point. Some concise documentation explaining the underlying architecture would be fantastic.
Re: Win9X clients logging in and browsing via VPN 3000
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
DocumentationCode download linksGoalRequirementLimitationsSupported ISR
and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and
UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity
options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in
HA DocumentationCode download linksGoalRequirementLimitationsSupported
ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and
UCS-E Blades:Step by Step ConfigurationCo...
Question I am currently unable to specify "crypto keyring" command when
configuring VPN connection on my cisco 2901 router. The following
licenses have been activated on my router :