04-27-2001 06:04 AM - edited 02-21-2020 11:19 AM
I have a 2621 router and want to allow L2TP through for a VPN connection to a server. What IOS commands do I need to use to open the correct ports/protocols?
Thanks
Irvin
05-03-2001 06:50 AM
Unless youre locking down your traffic with access lists or the firewall feature set, L2TP should pass properly. Read the section on Configuring the Firewall to Allow VPN Packets at this url http://www.cisco.com/univercd/cc/td/doc/product/aggr/vpn5000/5000sw/conce60x/5001conf/ipsec.htm
05-03-2001 11:54 AM
I am using the firewall feature set in the 2621. Any other help?
05-09-2001 08:13 AM
As i understand it right, the tunnel is not ended on router. Than you just have to allow L2TP (ip protocol 115) to pass you router. So you have to modify your access list on out interface for inbound traffic like this : in global configuration mode "access-list number/name permit 115 source_address complementary_mask destinatination_address complementary_mask" and in interface conf mode "ip access-group number/name in". Now is your L2TP traffic passing your firewall.
Hope it helps.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: