You wuill have to enable split-tunneling on the ipsec group if you want to be able to access local resources while connected via the tunnel. The resource connectivity sounds like a name resolution problem
You will have to install NetBIOS over TCP/IP to enable windows remote browsing from Winnt 4.0 servers, I think this will help to solve the first problem. The second problem is to enable split tunneling on the concentrator (configure|user management|groups|modify groups|mode config|allow network in list to bypass the tunnel and choose VPN Client Local LAN). You also have to enable "Allow Local LAN" in the VPN Client settings.
I have the same problem browsing the neighborhood and with the address registered in WINS and DNS. If you are using a different block of ip addresses for vpn clients than the block of the LAN remember you must do this block routable within your LAN and if you have not so much clients try to assign them a permanent Ip address to every one. Then you can map their disks with the ip address for example, \\192.168.4.1\data...etc.
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in HA
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationCo...
I am currently unable to specify "crypto keyring" command when configuring VPN connection on my cisco 2901 router.
The following licenses have been activated on my router :