Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Windows terminal services and ...

Hell-o,

Just installed a pix515e at our satelite campus across our WAN. What do I need to do now, to pass thru the firewall to see all the Windows servers and workstations and be able to terminal service to the servers?

Any advise or suggestions greatly welcome.

TIA,

Gary

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Windows terminal services and ...

Just create a access-list entry to allow port 3389 from your ip the server you wish to Terminal to. Once this is done make sure the access-list is being applied to the external interface.

access-list 100 permit ip any any eq 3389

access-list 100 deny ip any any

access-group 100 in interface outside

1 REPLY
New Member

Re: Windows terminal services and ...

Just create a access-list entry to allow port 3389 from your ip the server you wish to Terminal to. Once this is done make sure the access-list is being applied to the external interface.

access-list 100 permit ip any any eq 3389

access-list 100 deny ip any any

access-group 100 in interface outside

117
Views
5
Helpful
1
Replies