Is it possible disable X-Auth for a particular Group, when it has been enabled globaly using the command "crypto map vpnmap client authentication internal-radius" for all Other groups ?
I need to have an IOS Router connected to the PIX using EzVPN Client, however with X-Auth enabled (which is enabled to take care of other groups with Software VPN Clients), the user will have to enter the username\password at the Router Console, which is not desired.
Well. This applies to the Site-Site VPN, which we have already configured this way. My question was for VPN Groups.
E.g. Lets say there are two VPN Groups with "Clients" and "EzVPN", X-Auth is enabled globally.
Now PC Clients using (Cisco VPN Software) connect to Group "Clients" and are propmpted for their Username\Password, which is fine.
However the Cisco IOS Routers connects to Group EzVPN, and has to go through X-Auth, which means that at the Cisco Router Console "a User" will have to type "crypto ipsec client ezvpn xauth" and then Enter Username\Passwd. This is What i Want to Avoid ?
If i can make an exception that though X-Auth is enabled globaly but Shouldn't be required for "EzVPN" group, Is it possible ?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...