Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

XML files dont copy to standby unit

Hi,

I have failover active/standby topology with two ASA (version 8.0.4), and Clientless SSL VPN configured.

I have created differents profiles, bookmarks and portal in this solution.

But when I try to see this files in the standby unit, I can't to see it. Why? I try it whit "write standby" but nothing... Any idea?

Best regards

1 REPLY
Bronze

Re: XML files dont copy to standby unit

The write standby command replicates the configuation to the running configuration of the peer unit; it does not save the configuration to the startup configuration. To save the configuration changes to the startup configuration, use the copy running-config startup-config command on the same unit on which you entered the write standby command. The command will be replicated to the peer unit and the configuration saved to the startup configuration.

http://www.cisco.com/en/US/docs/security/asa/asa81/command/ref/uz.html#wp1567205

145
Views
0
Helpful
1
Replies