I have two STM4 SDH capacities and one STM16 SDH spanning two cities over different service providers. See Attachment, I have two Cisco ONS 15454 in two cities, one of the ONS is connected to a GSR router serving as core router while the second ONS is connected to a 7609-S serving as MPLS-PE router, their is DOT1q tagging transparently carried over the SDH circuits between the two routers. I want to make these capacities one big Ethernet pipe (10G) at both ends, this fat pipe should be able to carry multiple VLANs between the attached routers at both ends. Is this achievable? if yes what kind of Ethernet cards do I require on ONS and the routers? Any supporting document will be highly appreciated.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...