Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

7600 - Supervisor-Other - Unknown

Hi,

am upgrade ios to router7600 but am upload new ios to sup-bootdisk only and then am reload the router i saw this log

Mod Ports Card Type                              Model              Serial No.
--- ----- -------------------------------------- ------------------ -----------
  1    0  2 port adapter Enhanced FlexWAN        WS-X6582-2PA       JAE120107Y3
  2    0  4-subslot SPA Interface Processor-400  7600-SIP-400       JAE1052J698
  5    2  Supervisor Engine 720 (Active)         WS-SUP720-3BXL     JAF1201AHCJ
  6    0  Supervisor-Other                       Unknown            Unknown

module 6 it can't boot.

am try to boot ios to last version but module 6 can't boot also.

Can anyone help me ?

3 REPLIES
Cisco Employee

Re: 7600 - Supervisor-Other - Unknown

Have you copied image to slavesup-bootdisk: as well ? Your standby is most likely stuck in ROMMON as bootvar is pointing to the image he cannot found on his flashdisk. Just connect to the console port of it, enter "boot", your system will end up in RPR redundancy mode, then copy image from active to standby and reload stanby (hw-module module..).

New Member

Re: 7600 - Supervisor-Other - Unknown

Why this slot can't boot from old ios on supboot-disk?

Cisco Employee

Re: 7600 - Supervisor-Other - Unknown

He can, but for that you need "boot system flash", otherwise if it wont find image to which startup-config is pointing, he will end up in the ROMMON.

2479
Views
0
Helpful
3
Replies
CreatePlease to create content