Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Allocate Same Bandwidth to Multiple Cisco Router sub-interfaces

Hi all,

Apologies if this has already been covered elsewhere.

I have a setup where clients connect to network resources through different

router subinterfaces each on a different network.

I would want to create a bandwith pool where two or four subinterfaces can share

the same assigned capacity either:

i,Equally

ii,or giving one subinterface priority on bandwidth

iii,or giving priority to the subinterface not using much and vice versa

Sample layout:

                        <-------- Gi0/2.4

   Pool              <-------- Gi0/2.5

(5120kbps)        <-------- Gi0/2.6

How best can I implement this?

Thanks in advance,

Chris

1 REPLY

Re: Allocate Same Bandwidth to Multiple Cisco Router sub-interfa

Hi all,

Apologies if this has already been covered elsewhere.

I have a setup where clients connect to network resources through different

router subinterfaces each on a different network.

I would want to create a bandwith pool where two or four subinterfaces can share

the same assigned capacity either:

i,Equally

ii,or giving one subinterface priority on bandwidth

iii,or giving priority to the subinterface not using much and vice versa

Sample layout:

                        <-------- Gi0/2.4

   Pool              <-------- Gi0/2.5

(5120kbps)        <-------- Gi0/2.6

How best can I implement this?

Thanks in advance,

Chris

Hi Chris,

Check out the below link for limiting the bandwidth in interfaces

http://blogs.techrepublic.com.com/networking/?p=404

http://www.ciscosystems.com/en/US/tech/tk543/tk545/technologies_tech_note09186a0080114326.shtml

Hope to Help !!

Ganesh.H

If helpful do rate the post

720
Views
0
Helpful
1
Replies