Allocate Same Bandwidth to Multiple Cisco Router sub-interfaces

[the_chris]

Hi all,

Apologies if this has already been covered elsewhere.

I have a setup where clients connect to network resources through different

router subinterfaces each on a different network.

I would want to create a bandwith pool where two or four subinterfaces can share

the same assigned capacity either:

i,Equally

ii,or giving one subinterface priority on bandwidth

iii,or giving priority to the subinterface not using much and vice versa

Sample layout:

                        <-------- Gi0/2.4

   Pool              <-------- Gi0/2.5

(5120kbps)        <-------- Gi0/2.6

How best can I implement this?

Thanks in advance,

Chris

[Ganesh Hariharan]

Hi all,
Apologies if this has already been covered elsewhere.
I have a setup where clients connect to network resources through different
router subinterfaces each on a different network.
I would want to create a bandwith pool where two or four subinterfaces can share
the same assigned capacity either:
i,Equally
ii,or giving one subinterface priority on bandwidth
iii,or giving priority to the subinterface not using much and vice versa
Sample layout:
                        <-------- Gi0/2.4
   Pool              <-------- Gi0/2.5
(5120kbps)        <-------- Gi0/2.6
How best can I implement this?
Thanks in advance,
Chris

Hi Chris,

Check out the below link for limiting the bandwidth in interfaces

http://blogs.techrepublic.com.com/networking/?p=404

http://www.ciscosystems.com/en/US/tech/tk543/tk545/technologies_tech_note09186a0080114326.shtml

Hope to Help !!

Ganesh.H

If helpful do rate the post