ASR5k transparent mode

Community Member

‎09-06-2013 12:09 AM

Hi,

in order to configure transparent mode in ASR5k to disable authentication and to allow everyone what is the appropriate commandso co

in SAMI module we used used to configure 'access-mode non-transparent' under the APN

what is the equivalent in ASR5k?
we have configured the following 2 commands and we still have authentication failure for the GTP user

aaa authentication subscriber none

apn {apn_name}

authentication allow-noauth

Labels:

Other Service Provider Subjects

Latest Documents

SPA122 with Router

Created by laluja21 on 04-21-2018 04:59 AM

Question: Have the phone connected and can ring out-but no sound coming from the handset - analog home phone - phone makes connection and pick up at the other end is ok. Can you help? Barry (Australia) Answer

iPXE boot in ASR9K

Created by kritmoha on 04-10-2018 03:03 AM

Question: Have the phone connected and can ring out-but no sound coming from the handset - analog home phone - phone makes connection and pick up at the other end is ok. Can you help?Answer Introduction iPXE boot in ASR9K &nbs... view more

XR:NCS5500/ASR9000 Persistent Loadbalancing or "Sticky ECMP"

Created by xthuijs on 04-06-2018 08:24 AM

This document applies to NCS5500 and ASR9000 routers and has been verified as such. Introduction traditional ECMP or equal cost multipath loadbalances traffic over a number of available paths towards a destination. When one path fails, the traffic gets r... view more