Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configure Sync-E on Cisco MWR2941

Dear friends,

I got a trouble when configure Sync-E on this Cisco Devices.

Topo1: Cisco7600 --- MWR1

This Topo is working fine because we can configure interface gigabit ethernet on Cisco 7600 as a Sync-E source with this command:

interface GigabitEthernet 3/1
synchronous mode
clock source internal

On MWR we use this command: network-clock-select 1 Sync 0


Topo2: Cisco 7600 --- MWR1 ---- MWR2

Configuration on 7600 and MWR1 are the same as Topo1 but the port to connect to MWR2 on MWR1 we can not configure it to transmit Sync-E like 7600.

I am using this IOS Release Notes for Cisco MWR 2941 Mobile Wireless Edge Router for Cisco IOS Release 12.2(33)MRB

Please help me to find out the trouble!

Thanks a lot,

Do Thanh Son

632
Views
0
Helpful
0
Replies