Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring DSL

                  In Cisco 2800 Router, I need to disable the T1 connection (63.131.60.112) and enable DSL on interface Fa0/2/0. May I know how to configure for DSL.

group 2
crypto isakmp key sdfedklQ1 address 66.150.207.97
crypto isakmp key sdfedklQ1 address 65.207.62.129
crypto isakmp key sdfedklQ1 address 63.131.70.130
!
!

!

!
!
!
ip ssh time-out 60
ip ssh authentication-retries 2
ip ssh version 2
!
!
!
interface FastEthernet0/0
description Warehouse LAN
ip address 10.11.0.1 255.255.255.0
no ip redirects
no ip proxy-arp
ip nat inside
ip virtual-reassembly
duplex half
speed auto
no cdp enable
no mop enabled
!
interface FastEthernet0/1
no ip address
ip accounting output-packets
duplex auto
speed auto
!
interface FastEthernet0/1.1
encapsulation dot1Q 10
ip address 63.131.60.112 255.255.255.240
ip inspect SDM_LOW out
ip nat outside
ip virtual-reassembly

no cdp enable
crypto map crypto-map-1
!
interface FastEthernet0/1.2
encapsulation dot1Q 20
ip address 10.100.0.14 255.255.255.252
no cdp enable
!

interface Serial0/0/0
Description Internet Qwest Circuit ID DS1IT-13943174
bandwidth 1536
ip address 72.166.15.46 255.255.255.252
no ip redirects
no ip proxy-arp
ip inspect SDM_LOW out
ip nat outside
ip virtual-reassembly
no cdp enable
crypto map crypto-map-1
!

interface FastEthernet0/2/0
ip address .....
  duplex auto
speed auto
!
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 63.131.60.111
no ip http server
ip http authentication local
no ip http secure-server
ip http timeout-policy idle 60 life 86400 requests 10000
!
!
ip nat inside source list pat-out interface FastEthernet0/1.1 overload
!
ip access-list extended inet-in
permit icmp any any
permit udp host 66.150.207.97 host 63.131.60.112 eq non500-isakmp
permit udp host 66.150.207.97 host 63.131.60.112 eq isakmp
permit esp host 66.150.207.97 host 63.131.60.112
permit tcp any host 63.131.60.112 eq 22
ip access-list extended pat-out
deny  ip any 10.0.0.0 0.255.255.255
deny  ip any 192.168.0.0 0.0.255.255
permit ip 10.11.0.0 0.0.255.255 any
ip access-list extended serial-in
permit icmp any any
permit tcp any host 72.166.15.46 eq 22

access-list 145 permit tcp host 10.11.0.116 host 10.20.0.3 eq www
access-list 145 permit tcp host 10.20.0.3 eq www host 10.11.0.116
access-list 146 permit udp host 10.11.0.116 any eq domain
access-list 147 permit icmp host 10.11.0.116 any
access-list 165 permit tcp any host 24.61.20.69
access-list 165 permit tcp host 24.61.20.69 any
no cdp run

!
!
!

Everyone's tags (2)
1 REPLY
Silver

Configuring DSL

Typically for a DSL link you should have an ATM interface in config.

Are you sure your link is not PPPoE or VDSL?

Can you paste here a show inventory?

879
Views
0
Helpful
1
Replies