Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connection between CRS 1 POS interfaces and 7600 POS Interfaces

Hi,

I am trying to connect a CRS 1 POS interface to a Cisco 7609 POS interface and i keep geting the following alarms, and the line protocol i s down on both device ends

RP/0/RP0/CPU0:at_crs_01#LC/0/2/CPU0:May 1 10:42:47.363 GMT0: spa_oc48[245]: %L2-SONET_LOCAL-4-ALARM : SONET0/2/0/2: SLOS cleared.

Please help!!

Attached are the configurations on the Devices

1 REPLY
Hall of Fame Super Silver

Re: Connection between CRS 1 POS interfaces and 7600 POS Interfa

Hello Obiora,

if the two are connected in back to back: one side provide the clock with

clock source internal

the other side should take the clock from line

clock source line

I would change one of the two in clock source line

Hope to help

Giuseppe

313
Views
0
Helpful
1
Replies