Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

downstream channel reached full rate

Gentlemen,

How to prevent new cable modems to register on a downstream channel reached full rate on the ubr10012 CMTS?

I mean, how to configure CMTS to automaticaly order Cable Modems to register in a second 252QAM downstream channel when the first is reached its maximum full rate?

Ie, If there are 30 Cable Modems using the first Downstream Channel and this channel reaches its maximum data rate, the next (31st) must to automaticaly use the second downstream channel! How can I do it on the ubr10012?

 

Thank you and best regards,

 

Roberto

Everyone's tags (1)
63
Views
0
Helpful
0
Replies
CreatePlease to create content