how to configure the memory settings based on the number of VSAs for Cisco service control Subscriber Manager?
Hey Good day to all,
please help with this; when installing the Service Control Management Suite Subscriber Manager scms-sm, and at the secound step where you have to determine the system memory settings, there are several attributes to be considered:
the maximum number of the subscribers
with or without qouta manager
number of VSAs used
so, my question is about the memory configuration parameters versus the number of VSAs used, since you must multiply with certain values, set already on a table on the Cisco website, but as shown in the example under the table these values are multiplied to all the attributes except that the example dosn't show the value of the temp-size memory;
so please confirm this to me:
the temporary memory size "temp_size" is not related to the number of VSAs implemented!
Question: Have the phone connected and can ring out-but no sound coming from the handset - analog home phone - phone makes connection and pick up at the other end is ok. Can you help?
Question: Have the phone connected and can ring out-but no sound coming from the handset - analog home phone - phone makes connection and pick up at the other end is ok. Can you help?Answer
iPXE boot in ASR9K
This document applies to NCS5500 and ASR9000 routers and has been verified as such.
traditional ECMP or equal cost multipath loadbalances traffic over a number of available paths towards a destination. When one path fails, the traffic gets r...