What you are describing doesn't sound normal. You shouldn't see XR Failure in the "show platform". You can see an MSC or other cards take multiple reboots before coming up depending on code previously on it and the code running on the CRS now. Can you put up a snippet of the "show logging" where we see the card fail to come up? Do you see something in the log where it says it failed?
Taking multiple reboots before coming up is normal. But my problem is, at one stage of booting process MSC hangs on the state of "MBI-Booting" and shows "IOS-XR failure" for the command "show platform".
This failure is shown after the following message in the console..
shelfmgr: %PLATFORM-SHELFMGR-2-NODE_REBOOT_RECEIVED : Node 0/5/SP about to reboot due to cause code:0x44, Cause: self-reset to use new boot image
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...