With a 5DS license, one DS channel is enabled from each controller from the card. Even with 5 DS license only in 20x20 LC, you should be able to assign DS channels from different controllers to the same DS bonding group (wideband-cable interface) so you should normally be able to do DS bonding with such a group.
Take into account that I'm not able to fully verify this locally since all my linecards are licensed with 20DS, but I believe it should be possible. I would suggest to have an official answer from your Cisco Sales Representative to be on the safe side.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...