My customer used many T1-MUX to connect MGX-VISM T1. There are FXO, FXS, E&M, & Low Speed Data from 2.4K,9.6K to 64K, sync or async. The MGX-VISM used AAL2 trunk,and codec G.729ab to handle Voice. MGX-VISM can connect FXO, FXS, & E&M to PBX. The Low Speed Data, MGX-VISM used AAL2 trunk, and G.711 or Clear Channel to handle data. Also, MGX-VISM can connect Low Speed Data to other T1-Mux. In the ATM netowk, I can use DS0-base to create virtual circuits to other site. Now, I try to migrate these T1-MUX to C7600, from ATM network to IP/MPLS network.
Migration T1 of T1-MUX from MGX-VISM to C7600.
Can C7600 support DS0 cross-connection Pseudowire?
Do you have any suggestion about migration T1-MUX from ATM to IP/MPLS?
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
IntroductionIn this article we'll discuss how to troubleshoot packet
loss in the asr9000 and specifically understanding the NP drop counters,
what they mean and what you can do to mitigate them. This document will
be an ongoing effort to improve troublesh...