recently in reporter appears some weird table at the end of the "Multi Package Bandwidth per Service" report (RPT_PUR).
The symptom is, that some of the services are named correctly, some of them are denoted with numbers, like this:
Names are OK, numbers are NOT OK.
Investigating the issue I found the following:
Named services are found in CM MySql/apricot/INI_VALUES table with matching name and "VALUE" with VALUE_TYPE="1". This VALUE is found, and matching the name in PQB/classification on services (or within unzipped xml)
Services only with numbers in the report: those numbers, treating them as "VALUE" field of the INI_VALUES table, does not hold any row with VALUE_TYPE="1", neither can be found such service number in PQB classification (or unzipped xml).
I.e. number "64"
mysql> select * from INI_VALUES where SE_IP like "172.x.y.z" AND VALUE like "64";
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...