actually everything looks like fine about this customer RP
the error message decoder provides the following feedback
1.%PIM-6-INVALID_RP_JOIN: Received (*, [IP_address]) Join from [IP_address] for invalid RP [IP_address]
A downstream PIM router sent a join message for the shared tree, which this router does not want to accept. This behavior indicates that this router will let only downstream routers join to a specific rendezvous point.
Recommended Action: Configure all downstream leaf routers to join to the RP that is allowed by upstream routers toward the validated rendezvous point.
Related documents- No specific documents apply to this error message.
There is any difference on this PE node ?
different IOS image, different model/platform?
There is built redundancy, that is the VRF site is multihomed and there are two PE nodes serving the site?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...