Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

My router boot in boot mode: router(boot)>

I have a router 7500 serie and he start on boot mode only "router(boot)>" i can't any interface, and i put the confreg to 0x2102, but i don't have change. please help my is very urgent

3 REPLIES
Hall of Fame Super Gold

Post the entire bootup

Post the entire bootup process.  I would like to see WHY the router goes into ROMmon.  

 

Maybe the IOS is corrupt.  Maybe you've got a wrong boot variable statement.  Maybe you've got a faulty hardware.

Cisco Employee

Hi,

Hi,

 

Can you use the command:

Router#remote command show bootvar

This will tell you what is the boot variable on the SP, Sometimes it does happen that your boot variable is different on RP and SP and upon reload the switch ends up in the Boot Loader prompt.

If this show anything apart from 0x2102, go to the global config change the variable to 0x2102 and again verify if it has been changed to 0x2102 on the SP. And then you will have to reload as this requires a reload to get changed on the SP.

Hope it Helps.

Regards,

Seemab 

New Member

Thanks for you help. now i

Thanks for you help. now i sure that my router is Defective.

82
Views
0
Helpful
3
Replies
CreatePlease to create content