Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Optical received/transmit power Cisco GSR12K

Hi Guys,

I am unable to find the optical received and transmit power on my interfaces a Cisco 12K box running below version.

IOS (tm) GS Software (C12KPRP-K4P-M), Version 12.0(33)S10, RELEASE SOFTWARE (fc1)

Hardware details are as below.

NAME: "Chassis", DESCR: "12410/PRP chassis, Hw Serial#: TBA09310138, Hw Revision: 0x00"
PID: 73-5318-3 rev 80 dev 0, VID: 0x00, SN: TBA09310138

NAME: "slot 29", DESCR: "GSR 12410 Fan tray"
PID: 800-5574-01 rev A0 dev 62379, VID: 1.0, SN: CAT08130WCM

NAME: "slot 0", DESCR: "4 port Edge Engine3 Gigabit Ethernet"
PID: 800-22811-06 rev A0 dev 0, VID: V00, SN: SAL09253HRH

NAME: "slot 2", DESCR: "1 port ISE OC12 Channelized to DS1/E1"
PID: CHOC12/DS1-SM-IR , VID: V00, SN: SAD092609NG

NAME: "slot 3", DESCR: "ISE 10G Modular Services Card v2"
PID: 12000-SIP-601 , VID: V04, SN: SAD1214050C

NAME: "SPA subslot 3/0", DESCR: "1-port 10 Gigabit Ethernet Shared Port Adapter XFP based"
PID: SPA-1XTENGE-XFP , VID: V03, SN: JAE1213CBWO

NAME: "subslot 3/0 transceiver 0", DESCR: "OC192 + 10GBASE-L"
PID: 10-1989-02XFP , VID: 02 , SN: ONT121110DX

NAME: "slot 4", DESCR: "ISE 10G Modular Services Card v2"
PID: 12000-SIP-601 , VID: V04, SN: SAD121404Y3

I tried using 

1)show controllers interface gi4/0/0

2)show interface gi4/0/0 controllers

3)show module (does not run)

Everyone's tags (4)
1 REPLY
New Member

Alright just found out :)

Alright just found out :)

router#show hw-module subslot 4/0 transceiver 0 status
The Transceiver in slot 4 subslot 0 port 0 is enabled.
Module temperature = 32.199 C
Transceiver Tx bias current = 70780 uAmps
Transceiver Tx power = 2 dBm
Transceiver Rx optical power = -3 dBm

95
Views
5
Helpful
1
Replies
CreatePlease login to create content