RTR configuration commands not showing in running config
We have rtr configured on some of our 3660 and 2600 routers, when you do a show rtr config it displays the config output. However, there is no actual rtr configuration in the running/startup config, no command lines relating to rtr whatsoever. The IOS versions are 12.2(29) and 12.3(13a). Is this normal?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...