Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SCA reporter not getting connected to database

Hi,

I am running CM with bundled databse (version 3.5.5), now when i am trying to connect the reporter with database, it is not getting connected. It is giving an error: "mandatory preferance"ip of sce for policy data" is not set".

I am attaching the screenshot of that,

I have checked the /etc/hosts file and timezone settings, all is fine.

Would someone suggest the way to resolve the issue.

Regards

Punit

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: SCA reporter not getting connected to database

Hi,

you should re-apply (what a stupid solution) configuration to your SCE device. Then, shutdown and start again a reporter or SCA BB and now you should be able to see the SCE address.

Please note that you can retrive your current configuration from SCE and then just apply the same config again.

That would do the trick.

HTH

Raja, Gaja i Vlaja

2 REPLIES
New Member

Re: SCA reporter not getting connected to database

Hi,

you should re-apply (what a stupid solution) configuration to your SCE device. Then, shutdown and start again a reporter or SCA BB and now you should be able to see the SCE address.

Please note that you can retrive your current configuration from SCE and then just apply the same config again.

That would do the trick.

HTH

Raja, Gaja i Vlaja

New Member

Re: SCA reporter not getting connected to database

Thanks Mika...

it worked....

333
Views
0
Helpful
2
Replies