Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SCE 2020:inline-cascade

Getting the below error message when I apply the following command under interface LineCard 0 'connection-mode inline-cascade physically-connected-links priority primary on-failure bypass'

### command ###

SCE2020-3(config if)#connection-mode inline-cascade physically-connected-links priority primary on-failure bypass

### Error message ###

Error - connection mode configuration can only be changed when Line Card is in '

no-application' or 'shutdown' mode.

### Interface LineCard0 ###

SCE2020-3#show interface LineCard 0

The application assigned to slot 0 is /tffs0/_release.sli

Silent is off

Configured shutdown is off

Shutdown due to sm-connection-failure is off

Resulting current shutdown state is off

WAP handling is disabled

SCE2020-3#

3 REPLIES
New Member

Re: SCE 2020:inline-cascade

It will not allow you to change the linecard setting while it is active. First shut down the line card then apply the command you want then no shut down it. If the system in production this might affect the traffic processing.

New Member

Re: SCE 2020:inline-cascade

kj

New Member

Re: SCE 2020:inline-cascade

Go to the interface linecard 0

then issue shutdown command

425
Views
0
Helpful
3
Replies
CreatePlease login to create content