cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
743
Views
0
Helpful
1
Replies

SCE 2020 not shaping uploads

pieterj
Level 1
Level 1

Wonder if anyone has advice on this,

We have configured a package for testing purposes to provide a PIR of 5mb/s upload and 5mb/s download. Its a very basic package that just matches all traffic and is then suppose to rate limit said traffic. What we have is that when doing a basic test to speedtest.net that downloads seems to be rate limited to a certain extent (Getting about 8mb/s at start and then drops down to 5 towards the end of the test) but with upload we are always getting a lot more, sometimes as high as 80mb/s but usually around 10mb/s, only on some occasions close to 6 or 7 but never as low as 5. Could this be a buffering issue or is there something else we need to set?

Thanks

PJ

1 Reply 1

pieterj
Level 1
Level 1

Nobody seen this behaviour? is this common?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: