I am trying to set Network Attack Notification for malicious traffic. I have set the Activation frequency to always, and after initializing the malicious traffic I could see that SCE has detect the attack and began to redirect the user to desired URL. Until that point everything is fine.
Now how can I remove the redirection from the subscriber? The documentation say (A Network Attack Notification is not dismissed at the end of an attack; subscribers must respond to it. )
How can a subscriber respond to the notification and how can I remove the notificationfrom the subscriber?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...