I am new to SCE functionality, I have a case where we want to deploy SCE8000 for DPI functionality in a mobile network environment.
So my question is how can the SCE receive the mapping between the IP address of the subscriber and the MSISDN of the subscriber(noting that the IP address is allocated to the subscriber via DHCP on the GGSN(non-Cisco)) in order for it to apply certain policies on a specific subscriber?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...