I am about to deploy an SCE8000 but have a technical issue reagrding the end user authentication. The SCE800 is to be deployed into an enterprise enviroment where the end users have access to there VLAN once there PC is switched on but in order to gain access to the internet they need to VPN to the ASA5580 using there AD credentials.
What I would like to do is integrate the ASA into the SM and CM so that the SM can have knowledge of the username and IP addresses associated at the time of the connection. There is no dot1x deployed on the wired network so I am looking for alternate solutions.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...