Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Still Fast-Switching mode for static route dialer command?

Hello

In my understanding static route dialer command sitll functions as fast-switching mode right? 

Here is the configuration and mode difference between static dialer and ppp ipcp route defautl command.

-------------

IOS version : 15.3(3)M3

[CEF mode]

interface dialer 1
 ppp ipcp route default

 

RS1#sh ip cef
Load for five secs: 0%/0%; one minute: 0%; five minutes: 0%
Time source is hardware calendar, *01:57:02.259 UTC Mon Aug 11 2014

Prefix               Next Hop             Interface
0.0.0.0/0            100.0.0.254          Dialer1

[FastSwitching Mode]

ip route 0.0.0.0 0.0.0.0 dialer1

RS1#sh ip cef
Load for five secs: 0%/0%; one minute: 1%; five minutes: 2%
Time source is hardware calendar, *02:01:55.419 UTC Mon Aug 11 2014

Prefix               Next Hop             Interface
0.0.0.0/0            attached             Dialer1

-------------------

But it seems that there is cef table for static dialer command.

I mean that CEF supporf for dialer-profile not fast-switching rifght? if so when does this support start? 

 

And here is the related information about 

[Configuring Dialer CEF]

http://www.cisco.com/c/en/us/td/docs/ios/dial/configuration/guide/12_4t/dia_12_4t_book/dia_cfg_dialer_cef.html#wp1029310

 

The Dialer Cisco Express Forwarding feature is not supported when a static route points to the Dialer without specifying a next hop IP address. When using Cisco IOS Release 12.3(11)T and higher, the ppp ipcp default route command may be used in Dialer interface configuration mode to work around this restriction.

-------

Benefits

Improved Performance

Cisco Express Forwarding is less CPU-intensive than fast-switching route caching. More CPU processing power can be dedicated to Layer 3 services such as quality of service (QoS) and encryption.

 

Best Regards,

 

59
Views
0
Helpful
0
Replies