strange input errors/ignored packets on NPE-G2 interfaces
I got a lot of input errors/ignored packets on interfaces of our NPE-G2 router. Interfaces use a different queue strategy, but got same situation with input errors. First of all i change media on gi0/2 (thinking about bad cable RJ45) and now it use a optical sfp . But situation didn't change.
GigabitEthernet0/1 is up, line protocol is up
Hardware is MV64460 Internal MAC, address is 0019.2f78.461b (bia 0019.2f78.461b)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 11/255, rxload 27/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 1., loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, media type is RJ45
output flow-control is XON, input flow-control is XON
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 13w5d
Input queue: 0/75/18534/90398 (size/max/drops/flushes); Total output drops: 0
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...