Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

suddenly address-family ipv4

Hi all,

I'm new to BGP & MPLS world, Can anyone explain why "address-family ipv4" command appeared suddenly in the show run configuration. i searched all the logs I'm sure i didn't configured that.

my IOS version Version 12.4(17a), If this behavior introduced by peers ?

Thanks in advance .

arul.

1 REPLY
Bronze

Re: suddenly address-family ipv4

Dear Arul ,

The "address-family ipv4" and "address-family vpnv4" will appear in your config when you configure mpls address famililies , eventhough you are not configuring ipv4 address families . all the noraml bgp statements and neighbors will come under ipv4 address family

http://www.cisco.com/en/US/docs/ios/12_1/switch/command/reference/xrdscmd1.html

Regards,

Haris

149
Views
0
Helpful
1
Replies