As per attached network diagram I have setup the VRF Cust_A between 6509-VLAN-RT
and the 2811-Cust-RT routers, which works as expected.
I am trying to inject global route into VRF and vice versa but I was only
successful to do so by adding a static default gateway 0.0.0.0/0 on the VRF with next hop pointing to the 6509-DMZ-RT and static route for the VRF VLAN pointing to the vlan interface.
By doing the above I am able to communicate between VRF VLAN and other Non-VRF VLAN's on the 6509-VLAN-RTR, but I am unable to communicate to VRF VLAN from 6509-DMZ-RT, in other words unable to communicate from outside of the 6509-VLAN-RT. Please check the attached config and advise what is happening wrong with my config.
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
Introduction Basic configuration for netflow Scale parameters for
netflow Netflow support Architecture Packet flow for netflow Inside the
LC CPU Netflow Cache size, maintenance and memory Sample usage Cache
Size Aging Permanent cache Characteristics Which...