Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

1020 booting loop.....Help

Hi

I have upgraded my controller to 4.2.130, and then I attempted to give one of my AP's a static IP address, and since then its in a booting loop.

I partially registers with the controller, and then reboots itself, and I cant ping it or reset the config.

What options do I have?

David

2 REPLIES
Hall of Fame Super Silver

Re: 1020 booting loop.....Help

What does the log show. You can see a join, but what error do you see after that. make sure the time is set correctly on the wlc, verify that there is not any ap authorization configured that may be blocking the ap from joining. Here is a doc you can go over to make sure you are setting up the network and wlc correctly:

http://www.cisco.com/en/US/docs/wireless/access_point/1000/quick/guide/ap1000qs.html#wp34036

-Scott
*** Please rate helpful posts ***
New Member

Re: 1020 booting loop.....Help

Thanks for your advice.

I managed to work out using the debug commands that the static IP was using a different subnet mask to the AP-Manager

Cheers

123
Views
0
Helpful
2
Replies
CreatePlease to create content