Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1100 bridge - MAC problems

Two 1100's are setup as a bridge, both connected to a 1100 running as a root-AP.

A problem occurs when a client leaves the area where the root-AP is and goes to one of the areas where a bridge-AP is providing connectivity:

no traffic is bridged. (Workaround for this issue is a 'clear bridge' command on the bridge-AP)

Bridge configuration:

!

bridge irb

!

interface Dot11Radio0

bridge-group 1

bridge-group 1 spanning-disabled

!

interface FastEthernet0

bridge-group 1

bridge-group 1 spanning-disabled

!

bridge 1 protocol ieee

bridge 1 route ip

!

The root-AP has the following config:

interface Dot11Radio0

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

bridge-group 1 spanning-disabled

!

interface FastEthernet0

bridge-group 1

no bridge-group 1 source-learning

bridge-group 1 spanning-disabled

!

bridge 1 route ip

Anyone who can tell me why the bridge is blocking roamed clients?

118
Views
0
Helpful
0
Replies
CreatePlease login to create content