Started playing with Wism module and WLC. Before deploying, I upgraded an 1121ap to lwapp firmware. Configured DHCP option 43 and connected AP. In a continuous loop, the AP will associate with WismA and disassociate soon after and will never remain associated.
lwapp debug shows "Slot ID 0 is not valid for AP 00:12:01:2c:6d:24". I have searched for this message on the cisco site and internet and am unable to find anything for it.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...