Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

1121 Update Failure

the 1121 version wan 12.3-4 i upgrade to 12.3-8 the upgrade was successfull, but after restar the AP the led 1,3 flash in red, the led 2 flash in green after that the ap restar and i makes again, somebody knows how to fix this?

this is the result:

Red

Green

Red

No Cisco IOS image file.

how cai fix this?

1 REPLY
Silver

Re: 1121 Update Failure

Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the access point. Press and hold the MODE button while you reconnect power to the access point.Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds), and release the MODE button. Wait until the access point reboots as indicated by all LEDs

turning green followed by the Status LED blinking green. Then reload the imgae using TFTP.

109
Views
1
Helpful
1
Replies