Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

mx
New Member

1130 LWAP intermittantly stops

Hi.

I have an install using 1130 LWAP's and a 4400 controller. In one of the conference rooms clients get booted for a second then they reassociate. Using netstumbler I can see it graphically where the AP just stops transmitting.

There also appears to be a fair amount of rogue AP's (nearby buildings) which doesnt help.

Is it possible that it is constantly adjusting to prevent interference by the other AP's and in the process its dropping the clients?

On that note, is it possible to configure a lightweight AP to NOT adjust? i.e. set it to channel 6, 100 mw and keep it that way no matter what? I didnt see that option anywhere in the controller or within WCS.

Bob

1 REPLY
mx
New Member

Re: 1130 LWAP intermittantly stops

I attached a net stumbler screen shot to show where it drops off

98
Views
0
Helpful
1
Replies
CreatePlease login to create content