I am having a problem with a setup that uses 1130AG access points. One is acting as the root with three more wireless repeaters.
Problem is that everything connects fine, and then all of a sudden will stop working. A client will connect, but not be ale to get an IP address. All of the configs are correct, and there is no security that could be causin the conflict. My only thougt, as this setup worked perfectly for moths, is that the radio is going bad.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...