Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1130AG not passing DHCP and failed access

Hi,

we have recently enocuntered a problem with one of our 1130AG AP's

The device broadcasts the two SSID's we have fine, we can authenticate to them but we arnt getting DHCP address through, the connection sits in a Aquring IP Address for a few minutes then enters limited or no connectivty mode, more annoyingly is when we input a static address the connection enters a connected state, but we cant do anything or get anywhere

The device has similar config as two other AP's we have and they work fine without incident, its just perplexing us as we cant understand what the issue is with the device,

Would anybody have any ideas what could be causing such a problem?

Its on the latest IOS

Cheers in advance

2 REPLIES
Gold

Re: 1130AG not passing DHCP and failed access

Did you make sure the switchport that the AP is connected to is configured as a trunk?

Re: 1130AG not passing DHCP and failed access

I always say follow the packet and you will find your anwser.

1 - Check DHCP helper on your router if this isnt correct your DHCP request wont get routed properly

2 - Can you extend your vlan to a wired port and plug your PC into the port and see what happens

3 - Are your DHCP scopes set up properly -- are you out of addresses --- are exclusions set up properly?

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
374
Views
0
Helpful
2
Replies
CreatePlease login to create content