I have this AP and it has a problem. If I plug in only the power injector with nothing plugged into the network side of the injector, nothing happens. If I plug an ethernet cable from at Linksys POE switch to the network side nothing happens. If I plug an ethernet cable from a Cisco 3560G POE switch to the network side of the power injector it powers fine.
Once the AP is booted, I can pull the cable from the network side of the injector to the Cisco 3650 and the AP will continue to run. Have tried multiple different pwrinj3 and AC adapter combination and nothing works. I know it isn't the power injector that is the problem. Something in the AP is not working correctly.
Once the AP has been running for a while, if I unplug the power injector from the AP it will die, but if I plug it in again in less than 30 seconds the system will boot again just fine. What is it about the 3560G that allows the AP to boot when nothing else will.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...