Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1131 in autonomous mode. Not sure the below is even possible

Hi all,

  My boss asked me to try and set up an 1131 with 2 SSID's; serve dhcp for both SSID's from the AP and I cant trunk from f0 because the device the AP will connect to cant accept dot1q.  Does anyone know if this is possible?  If so pointing me at a doc would be greatly appreciated.

Thanks,

Bill

1 REPLY
Hall of Fame Super Gold

Re: 1131 in autonomous mode. Not sure the below is even possibl

Can be done.  Don't create any subinterface.  Just put the two SSIDs into the radio interface.

180
Views
0
Helpful
1
Replies
CreatePlease login to create content