Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

p21
New Member

1131ag inline power problem

I have a 4402 (sw 3.2.78) controlling 1131ag's. The APs work fine with inline power but some I need to use power injectors (AIR-PWRINJ3 are the ones to use according to website) I used one of these injectors with the power supply that came with the 1131ag it works fine over a shore 1m cable, but as soon as I install it over any lenght of cable the 4402 reports that the 1131ag does not have enough inline power (Thu Feb 23 01:56:17 2006 [ERROR] spam_lrad.c 1892: AP 00:15:2c:4a:1e:30 has not enough in-line power to enable radio slot 0)

Any ideas?

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: 1131ag inline power problem

Try turning off cdp on the switchport you're connected to. I had this problem with LWAPP ap's and there's a bug in 12.3.7JX2 that is supposed to be fixed with 12.3.8 release. Turning off CDP will fix the issue.

2 REPLIES
New Member

Re: 1131ag inline power problem

Try turning off cdp on the switchport you're connected to. I had this problem with LWAPP ap's and there's a bug in 12.3.7JX2 that is supposed to be fixed with 12.3.8 release. Turning off CDP will fix the issue.

p21
New Member

Re: 1131ag inline power problem

Thank you that worked, Turn of CDP!

214
Views
0
Helpful
2
Replies
CreatePlease login to create content