I have 5 1131ag access points connected through a 6012 powerdsine midspan to provide POE. 2 of the units power up ok but the other 3 do not enable the radios. The 2 that are working are showing as drawing 8 watts but the other 3 are only showing 4 watts. They are all then connected onto a cisco WS-C3548-XL-EN running Version 12.0(5.2)XU of the os. The 2 that are working are on ports 8 and 9 on the cisco switch and the others are on ports 11,32 and 47. I have tried various combinations of the pre-standard and power-injector settings on the WLC4404 which I am using. Any ideas would be greatly welcome.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...