Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1230AG - cannot access express setup page

Hi, I just got a WAP 1230AG and i hyper terminaled in and saw the WAP starting up and assigning a 10.0.0.1 default address. I cannot access that page in IE! i have tried removing the external antenna, disconnecting the ethernet cable and all of these with resetting to factory default. also tried giving myself a manual ip of 10.0.0.1 with 255.255.0.0 subnet. i cannot access it! someone please help! Thanks.

  • Other Wireless - Mobility Subjects
1 REPLY
Green

Re: 1230AG - cannot access express setup page

The radios are off by default, I believe.

THe AP will come up with a 10.0.0.1/8 address. You need to connect a PC with any 10.0.0.0/8 address to the FastEthernet port and point your browser to 10.0.0.1.

OR, since you are already successfully console-attached, add a compatible address and mask to the BVI interface and attach it to your LAN and access it from any PC.

Your initial configuration has to be from an Ethernet-wired PC.

Good Luck

Scott

100
Views
0
Helpful
1
Replies
This widget could not be displayed.